Biology Question

Hi, I have done the part1. What you need to do is to revise my part 1 and do part 2.

Just a few relevant notes on the grading rubric and what to do for part II

You should solve the problem that you set out to solve in part I (or if your problem changed since part I due to changing design considerations, simplifications, or other reasons, then you should solve the new problem).

The turned in portion for part II should include all of the components in part I plus:

Initial estimate of expected results: What do you expect the results of your calculation will be? Take a guess at the final calculated value. You will not be graded on accuracy. This is just good practice, since if you are way off on your estimate it may indicate that there is something wrong with your calculation or that something is happening in the system that you were not expecting.

Solution: Work the solution to the problem. The result could be a single numeric value, plots, or in some cases values plus a selected component based on your calculation (a specific motor or battery that you could purchase for example). There is not set criteria here. Your solution should adequately and fully answer your posed question. It is up to you what form the data should be shown in.

Analysis / Interpretation: What does your solution say? How will this influence your design decisions going forward? Do the numbers make sense? Do you feel that the calculation accurately represents the real-world conditions or are they in error in some way? Think about your solution and what it means.

Clarity / neatness of work: Remember to be consistent with variable names and symbols. Pay attention to units. Make sure all of your variables are identified with descriptive text (just a few words) that show what they represent. i.e.

g = gravity (9.81 ms2

m

s

2

)

μ

μ

= dynamic viscosity (Nsecm2

N

sec

m

2

)

Hope this helps.

What I’m going to send you is the part I did and the teacher’s comment

The first one I posted was specifically about what and how the second part of the personal analysis needed to be done, and then the pdf was some of his more specific requirements. This is the part1 I did and the teacher’s comment. Plz check.

The format should be look like the file, but writer can type it, I can hand writing it, but needs a detailed analysis