Design the hydraulic circuit and electro hydraulic circuit for the vehicle lift application.
Design and demonstrate the electro-hydraulic circuit that meets the following requirements
Use a 4/3 solenoid operated directional control valve to actuate the cylinder.
The cylinder should lift the car to half its maximum position when PB1 is pressed. the lift will stop after being contact with the limit switch (mid position)
Then, the cylinder should lift the car to its maximum position after 5 seconds (use the ON-Delay timer).
If the PB2 is pressed at any period of time, the cylinder should return to its initial/home position
incorporate memory circuit for pushbutton PB2.
Repeat this procedure for 10 continuous trials. use your student ID for name of the counter.
Include the functional diagram (Cylinder, sensors, Timer, Counter and DCV)Title:1.Introduction2.Objectives3.Materials4.Procedure5.Results6.Discussion7.Conclusion8.ReferencesTitle:1.Introduction2.Objectives3.Materials4.Procedure5.Results6.Discussion7.Conclusion8.ReferencesTitle:1.Introduction2.Objectives3.Materials4.Procedure5.Results6.Discussion7.Conclusion8.References
Do My Essay For essays are NOT intended to be forwarded as finalized work as it is only strictly meant to be used for research and study purposes. Do My Essay For does not endorse or condone any type of plagiarism.